ShopReady Draft 2D · 1:09 · narrated, with captions

A flip-up cabinet door on a gas strut, part 1 of 7: The cabinet from the side

A wall cabinet drawn from the side on a blank drawing: bottom, back, top and shelf as rectangles with typed sizes, the door hung in front, and the hole for its hinge pin. Corners are clicked where they snap, and the top is the bottom copied corner to corner.

NextA flip-up cabinet door on a gas strut, part 2 of 7: A pin, stops, and a pull by hand

This is one part of a longer film

Whole project · 7:09

A flip-up cabinet door on a gas strut: the whole project

A wall cabinet's flip-up door, from a blank drawing to the strut to buy and where to screw it. The cabinet is drawn from the side with rectangles and typed sizes; the door is pinned at its hinge with stops and pulled by hand; Check for hits finds the door's back corner binding on the cabinet top and the Clearance tool gives it a 2 mm reveal. A gas strut between two drawn studs is sized by the program (71.6 N holds this 3 kg door level; an 80 N strut is fitted), let go to see the door stay shut and stay open, and its fixing point is tried in a worse place and put back. The last chapter reads off the strut's lengths, saves a film of the swing and dimensions the fixing points.

The rest of this project

Chapter · 52 s

A flip-up cabinet door on a gas strut, part 2 of 7: A pin, stops, and a pull by hand

Chapter · 1:03

A flip-up cabinet door on a gas strut, part 3 of 7: Where it binds, and the fix

Chapter · 1:11

A flip-up cabinet door on a gas strut, part 4 of 7: Fixing points, weight, and a strut

Chapter · 55 s

A flip-up cabinet door on a gas strut, part 5 of 7: The strut to buy

Chapter · 1:13

A flip-up cabinet door on a gas strut, part 6 of 7: What the hinge holds, and moving a fixing point

Chapter · 1:45