ShopReady Draft 2D · 37 s · narrated, with captions
The Array tool: a short lesson
The Array tool: repeat the selection in a line, grid, circle, or along a path. One of the program's own built-in demonstrations, in its own words.
This is one part of a longer film
More in every tool, one at a time
Lesson · 25 sThe Angle tool: a short lesson
The Angle tool: the angle between two lines: click one, then the other, then where its arc goes. One of the program's own built-in demonstrations, in its own words.
Lesson · 20 sThe Arc 3-point tool: a short lesson
The Arc 3-point tool: arc through start, middle, and end. One of the program's own built-in demonstrations, in its own words.
Lesson · 21 sThe Arc center tool: a short lesson
The Arc center tool: arc from center, start, and end. One of the program's own built-in demonstrations, in its own words.
Lesson · 23 sThe Center rectangle tool: a short lesson
The Center rectangle tool: rectangle from its center; type width,height. One of the program's own built-in demonstrations, in its own words.
Lesson · 24 sThe Chamfer tool: a short lesson
The Chamfer tool: cut a corner at an angle. One of the program's own built-in demonstrations, in its own words.
Lesson · 19 sThe Circle 2-point tool: a short lesson
The Circle 2-point tool: circle across two points (the diameter). One of the program's own built-in demonstrations, in its own words.