Skip to the page
ShopReadyCabinetsDraftFieldToolbeltCompare

ShopReady Draft 2D · 1:48 · narrated, with captions

Longer than the machine, and cut from both faces, part 2 of 3: Cut in tiles

The 1800 mm bookcase side is cut a tile at a time. Cut this piece in tiles is ticked, the tile's length typed, and the seams appear on the drawing; each tile shows its own paths between its seams, dowel holes on a seam place the next tile, and the simulator checks the tile in hand.

Before thisLonger than the machine, and cut from both faces, part 1 of 3: A bookcase side and its jobNextLonger than the machine, and cut from both faces, part 3 of 3: A tray from both faces

This is one part of a longer film

Whole project · 4:37

Longer than the machine, and cut from both faces: the whole project

Two router jobs that need the stock moved by hand, set up from blank drawings. A bookcase side 1800 mm long is drawn by typed sizes, its housings pocketed and its outline tabbed, then cut in three tiles with seams shown on the drawing and dowel holes that place the next tile. A tray is cut from both faces: side two is added as a second piece, an operation is sent to it, and side one drills the dowel holes the board is turned over on. Each tile and each side is its own program, checked in the simulator and saved with the drawing.

The rest of this project

Chapter · 1:22

Longer than the machine, and cut from both faces, part 1 of 3: A bookcase side and its job

Chapter · 1:51

Longer than the machine, and cut from both faces, part 3 of 3: A tray from both faces