Skip to the page
ShopReadyCabinetsDraftFieldToolbeltCompare

ShopReady Draft 2D · 1:51 · narrated, with captions

Longer than the machine, and cut from both faces, part 3 of 3: A tray from both faces

A new drawing: a tray with a well on top and two finger grips underneath. The well and the outline are cut from side one; Add side two makes a second piece for the board turned over, the grips' pocket is sent To Side two, side one drills two dowel holes on the line the board turns over about, and side two is simulated.

Before thisLonger than the machine, and cut from both faces, part 2 of 3: Cut in tiles

This is one part of a longer film

Whole project · 4:37

Longer than the machine, and cut from both faces: the whole project

Two router jobs that need the stock moved by hand, set up from blank drawings. A bookcase side 1800 mm long is drawn by typed sizes, its housings pocketed and its outline tabbed, then cut in three tiles with seams shown on the drawing and dowel holes that place the next tile. A tray is cut from both faces: side two is added as a second piece, an operation is sent to it, and side one drills the dowel holes the board is turned over on. Each tile and each side is its own program, checked in the simulator and saved with the drawing.

The rest of this project

Chapter · 1:22

Longer than the machine, and cut from both faces, part 1 of 3: A bookcase side and its job

Chapter · 1:48

Longer than the machine, and cut from both faces, part 2 of 3: Cut in tiles