ShopReady Draft 2D · 1:25 · narrated, with captions

A photo on wood, part 2 of 4: Dots, shades and how fine

The picture's row in the Laser job is clicked and its way of burning is changed one after another, the small before-and-after pictures and the drawing following each time: Newsprint, Threshold, Grayscale, and back to Dither. Brightness and contrast are dragged up, which clears the background and shortens the run; Lines apart goes from 0.1 to 0.15 mm, which shortens it again. The drawing is zoomed in until the single dots show.

Before thisA photo on wood, part 1 of 4: The picture comes in NextA photo on wood, part 3 of 4: A material test

This is one part of a longer film

Whole project · 4:26

A photo on wood: the whole project

A photo was engraved on wood and cut out with a frame. The film shows the picture window at its Laser choice, the picture on the drawing shown as it will burn, the ways of burning it (Dither, Newsprint, Threshold, Grayscale), brightness, contrast and line spacing with the run time following, the dots seen close up, a material test made from its numbers, a frame drawn on a Cut layer, and the preview with its clock.

The rest of this project

Chapter · 1:01

A photo on wood, part 1 of 4: The picture comes in

Chapter · 1:09

A photo on wood, part 3 of 4: A material test