Skip to the page
ShopReadyCabinetsDraftFieldToolbeltCompare

ShopReady Draft 2D · 1:28 · narrated, with captions

Round work, and a cabinet laser, part 2 of 2: The same job for a cabinet laser

A pretend cabinet laser (to try it with nothing plugged in) is added by hand, and the Laser job is at once made for it: it checks the job against the laser's 600 by 400 bed and says the band is off its edge, which Start from: Where the head is now puts right; and it says this laser's rotary is set at its own panel. Save the program... writes the laser's own kind of file; Send to the machine hands the same file to the Machine window, which says plainly that the head is moved and the job framed at the laser's panel. Connect, Start (asked about once), and the whole file is on the pretend laser and started.

Before thisRound work, and a cabinet laser, part 1 of 2: A band of lettering for a tumbler

This is one part of a longer film

Whole project · 3:02

Round work, and a cabinet laser: the whole project

A band of lettering was made for a tumbler turned on a rotary, and the same job was then made for a cabinet laser. The film shows drawing the band flat and standing it on end, the laser job's Round work on a rotary with its warning and its sums, a pretend cabinet laser added by hand, the job checked against that laser's bed, the program saved as the laser's own kind of file and sent, and the plain words that the head is moved at the laser's own panel.

The rest of this project

Chapter · 1:42

Round work, and a cabinet laser, part 1 of 2: A band of lettering for a tumbler