Skip to the page
ShopReadyCabinetsDraftFieldToolbeltCompare

ShopReady Draft 2D · 34 s · narrated, with captions

The Clearance tool: a short lesson

The Clearance tool: room between working parts: click the part to move, then the part it works against, and it is set the gap from it. Or an opening drawn for a part, with room all round. One of the program's own built-in demonstrations, in its own words.

Before thisThe Circle tool: a short lessonNextThe Construction line tool: a short lesson

This is one part of a longer film

Film · 10:31

Every tool, shown

All forty-four tools in the palette, each demonstrated by the program itself on a scratch drawing, with the tool's name, its key and what it does beside it. Chapters for every tool.

More in every tool, one at a time

Lesson · 25 s

The Angle tool: a short lesson

The Angle tool: the angle between two lines: click one, then the other, then where its arc goes. One of the program's own built-in demonstrations, in its own words.

Lesson · 20 s

The Arc 3-point tool: a short lesson

The Arc 3-point tool: arc through start, middle, and end. One of the program's own built-in demonstrations, in its own words.

Lesson · 21 s

The Arc center tool: a short lesson

The Arc center tool: arc from center, start, and end. One of the program's own built-in demonstrations, in its own words.

Lesson · 37 s

The Array tool: a short lesson

The Array tool: repeat the selection in a line, grid, circle, or along a path. One of the program's own built-in demonstrations, in its own words.

Lesson · 23 s

The Center rectangle tool: a short lesson

The Center rectangle tool: rectangle from its center; type width,height. One of the program's own built-in demonstrations, in its own words.

Lesson · 24 s

The Chamfer tool: a short lesson

The Chamfer tool: cut a corner at an angle. One of the program's own built-in demonstrations, in its own words.