ShopReady Draft 2D · 1:04 · narrated, with captions

A carved shop sign, part 3 of 7: The V-carve

Lettering, border and emblem are selected with one window and V-carved: a 90 degree V-bit, a deepest cut of 3.5 mm, and a 1/8 in end mill to clear the flat floors, which takes the job from about 40 minutes to 22.

Before thisA carved shop sign, part 2 of 7: A border and an emblem NextA carved shop sign, part 4 of 7: Cutting it out

This is one part of a longer film

Whole project · 7:42

A carved shop sign: the whole project

A carved shop sign followed from a blank drawing to a machine. A 600 by 300 mm board is drawn by typing its size; WORKSHOP is set in a carving font round an arc; a border band is made by two offsets; an emblem is traced from a picture. Everything inside the edge is V-carved, with an end mill clearing the flat floors; the outline is cut out last, ramped in, on four tabs placed by hand, starting on the bottom edge. The simulator finds nothing to fix, a job sheet and three programs are written, and the first program is framed, checked, started, paused, resumed and run to its end on a pretend router.

The rest of this project

Chapter · 1:12

A carved shop sign, part 3 of 7: The V-carve

This is one part of a longer film

A carved shop sign: the whole project

The rest of this project

A carved shop sign, part 1 of 7: The board and its lettering

A carved shop sign, part 2 of 7: A border and an emblem

A carved shop sign, part 4 of 7: Cutting it out

A carved shop sign, part 5 of 7: Checked, and a job sheet

A carved shop sign, part 6 of 7: To the machine (a pretend router)

A carved shop sign, part 7 of 7: Start, pause, resume, done (a pretend router)