Skip to the page
ShopReadyCabinetsDraftFieldToolbeltCompare

ShopReady Draft 2D · 1:31 · narrated, with captions

A carved shop sign, part 6 of 7: To the machine (a pretend router)

Send... hands the job's first program to the Machine window. A pretend router is added (a pretend machine, to try it with nothing plugged in), connected and homed; the head is jogged to the board's corner and zero is set; Frame runs the head round the program's box; Check has the controller read every line with nothing moving.

Before thisA carved shop sign, part 5 of 7: Checked, and a job sheetNextA carved shop sign, part 7 of 7: Start, pause, resume, done (a pretend router)

This is one part of a longer film

Whole project · 7:42

A carved shop sign: the whole project

A carved shop sign followed from a blank drawing to a machine. A 600 by 300 mm board is drawn by typing its size; WORKSHOP is set in a carving font round an arc; a border band is made by two offsets; an emblem is traced from a picture. Everything inside the edge is V-carved, with an end mill clearing the flat floors; the outline is cut out last, ramped in, on four tabs placed by hand, starting on the bottom edge. The simulator finds nothing to fix, a job sheet and three programs are written, and the first program is framed, checked, started, paused, resumed and run to its end on a pretend router.

The rest of this project

Chapter · 1:12

A carved shop sign, part 1 of 7: The board and its lettering

Chapter · 58 s

A carved shop sign, part 2 of 7: A border and an emblem

Chapter · 1:04

A carved shop sign, part 3 of 7: The V-carve

Chapter · 1:32

A carved shop sign, part 4 of 7: Cutting it out

Chapter · 53 s

A carved shop sign, part 5 of 7: Checked, and a job sheet

Chapter · 1:43

A carved shop sign, part 7 of 7: Start, pause, resume, done (a pretend router)