ShopReady Draft 2D · 1:43 · narrated, with captions

A carved shop sign, part 7 of 7: Start, pause, resume, done (a pretend router)

The check found nothing wrong. Start asks once, then the program runs on a pretend router: a bar shows the line it is on, the time gone and the time left; Pause holds the head, Resume goes on, and the Speed slider changes the feed as it runs. When it is done the next tool's program is already made ready, and the window says which bit to load. The film ends on the finished sign drawing.

Before thisA carved shop sign, part 6 of 7: To the machine (a pretend router)

This is one part of a longer film

Whole project · 7:42

A carved shop sign: the whole project

A carved shop sign followed from a blank drawing to a machine. A 600 by 300 mm board is drawn by typing its size; WORKSHOP is set in a carving font round an arc; a border band is made by two offsets; an emblem is traced from a picture. Everything inside the edge is V-carved, with an end mill clearing the flat floors; the outline is cut out last, ramped in, on four tabs placed by hand, starting on the bottom edge. The simulator finds nothing to fix, a job sheet and three programs are written, and the first program is framed, checked, started, paused, resumed and run to its end on a pretend router.

The rest of this project

Chapter · 1:12

A carved shop sign, part 7 of 7: Start, pause, resume, done (a pretend router)

This is one part of a longer film

A carved shop sign: the whole project

The rest of this project

A carved shop sign, part 1 of 7: The board and its lettering

A carved shop sign, part 2 of 7: A border and an emblem

A carved shop sign, part 3 of 7: The V-carve

A carved shop sign, part 4 of 7: Cutting it out

A carved shop sign, part 5 of 7: Checked, and a job sheet

A carved shop sign, part 6 of 7: To the machine (a pretend router)